Kawasaki ATV Forum banner

valve clearance v700

29K views 4 replies 5 participants last post by  05-BF-750 
#1 ·
no mods if that even matters should my exhaust be at 0.25 mm inlet at 0.15mm ?????
 
#3 ·
Don't forget to ignore the timeing marks and turn the motor over a 1/2 turn past where the valves stopped moving.
 
#4 ·
I set mine .004 intake and .006 exhaust for best performance but you will need to check them every few months if you set them that colse, but .008-.010 is going to be loose as hell and very noisy on the exhaust valves. Most set there valves at .005 & .007 or .006 & .008 to be worry free about it.
 
#5 ·
Yep I set mine at .005 IN and .007 EX
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top