Kawasaki ATV Forum banner
carb problem

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-4 of 4 Results
  1. Kawasaki Brute Force/Prairie/Bayou
    I just put a new carb in my 360 today. The last carb was causing it to idle to high to the point where I couldn't change gears. After I got the new carb in I adjusted the idle screw and it finally started idling fine. I put it in gear and when I started to give it a lot of gas it kinda sputtered...
  2. Kawasaki Brute Force/Prairie/Bayou
    hello there, i've been trying to get an 03 prairie 650 running that i picked up a few weeks ago. i've rebuilt the carbs and it only leaks after i turn it over. it's pouring out of the t fitting line that goes up into the air box from between the two carbs. bike is completely stock and it was...
  3. Kawasaki Mojave/Lakota
    I have a 95 Mojave 250, when I first got it I could kick start it but would bog down at full throttle. I rebuilt the carb with stock jets 35 Pilot 55 Starter 132 Main It then wouldn't kick start but after I bump started it, it would run good other than the high idle. Most recently I...
  4. Everything Else
    Hello I have a 95 Kawasaki mojave 250 the problem i am having is the it falls on its face when you give it more than a 1/4 throttle it starts sputtering and dying but usually doesn't shut off. it was just rebuilt and was bored 0.20 over new valves and all the carb has been rebuilt and cleaned...
1-4 of 4 Results