Search Results for ‘kawasaki’

Hey i have a 91 bayou 300 and i have stater cover off and took the starter idle limiter out and noticed it doesnt not spin freely one way. I think it could possible be stuck or something, or how much force does it require to spin one way. Any help would be great thanks!

Hi. I recently purchased a 1996 Kawasaki Lakota 300. It has some issues with the clutch slipping so I decided to replace the friction plates. After I did that it was even worse than before. Acts like the clutch won't release. I ended up replacing the adjuster screw and also the centrifugal...

So i installed some new 12v led lights. When I first started the quad the lights turned on and worked until I put it into gear and started driving. Now the lights won't turn in any more. I put a normal florescent light and it works fine. I had my choke in and the bike was reving super high so I...

I have a 1993 kawasaki mojave and I have had this problem for a while and now decided to fix it now. When riding in first gear the quad barely moves, but when you open the throttle all the way the power will kick in. I usually have to cruise around in 2nd gear because 1st gear has no power...

Factory takeoffs from Kawasaki Mule Pro Fxt Ranch Edition. Tires and wheels were removed with 10 miles on unit. No patches or plugs. Lug nuts and washers included.

I picked up a Kawasaki prairie 300 4x4, I drove it 8hrs straight (hard riding) I'm sure I can figure out how to get the starter to work again but I'm very confused. There is one wire going to it, makes sense it's the positive and the engine is the ground, NOPE it's the negative and the positive...

Hello, I’m looking to sell my 1988 Kawasaki Tecate 4. I live in San Diego, CA All original plastics and decals Aftermarket pipe Twist throttle Just put brand new tires on it in December 2021, and have only taken it out twice since then All stock engine I have a full set of spare tires for it...

I have a mule 2510 kaf620a I bought it from a guy it had been flooded but still ran I flushed the oil replaced the throttle cable the choke cable the spark plugs and the carburetor it is smoking bad I un bolted the muffle due to it being clogged it is still doesn’t run worth a crap and is white...

I'm looking for male connector for Kawasaki bayou 220 Starter Circuit Relay

can someone help me? had my battery disconnected so i recently reconnected it. accidentally put negative wire to positive on the battery and positive wire to negative on the battery with my key on. blew my solenoid fuse, so i replaced that. idles fine but when i put it on the road the atv won’t...

Hey guys I have a 2020 mule and I have a slight issue I can't figure out. When driving on flat ground it runs fine but as soon and I hit and incline to where the passenger side is higher than the driver side it wants to stall out. Please and thank you in advance

My daughter rolled her kfx90 now it idles fine but when you hit the gas it shuts off I thought maybe the carb got flooded so I drained it and put new gas in and it’s still doing the same thing any ideas would help

In need of exhaust cam for mojave 250 if I could buy one from someone? Or perhaps point me to where I can get one.

Hey whatsup guys, new here. So I'm looking for some aftermarket parts for my mojave 250, its mostly stock, with asv clutch lever, rear brake caliper block off, dg bumper, cobra exhaust,, protaper bars, 2 sets of rims and tires, im looking for a variety of things including but not limited to nerf...

I for the life of me cant get the rear drum "housing" (for lack of a better word) to break loose. I have spent many hours trying. As well as many hours on google, Unable to find a answer. Can some one provide me with the service manual for the rear brake. Or any wisdom. The wing nut on the back...

So here's the situation. I was out for the first cruise of the year last week. All was going good and i was on my way back to my house and when i was heading down the road holding the throttle steady and the wheeler acted like it was losing power for a few seconds. It came out of it quickly and...

Will taking the drive belt cover connectors off make it run poorly? Would running it without the connectors mess something up? Cause now it seems to run bad. Edit: Never mind, it was just a small mix up in resetting the belt. Didn't unplug the two wire after flipping the grey and black four...

So I put in a new clutch and have been riding for a few days. The problem is the shift lever has lost its..resistance...whenever you want to go into a new gear. What I mean is that the shift lever has no resistance when changing gears and changing gears is hard because it only changes at the...

I currently bought my brute force from a friend, it ran and drove perfectly fine unitl i starter going balls to the wall in some thick mud. Drove around the woods in high gear for acouple more miles when all of a sudden the rear end seemed to lock up. i got it home pull the rear diff apart...