Kawasaki ATV Forum banner
limp mode
1-4 of 4 Results
  1. Kawasaki Brute Force/Prairie/Bayou
    I have a 2013 Brute Force 750i EPS and this bike has ran great until recently. It goes into limp mode after driving 100 ft or so. I had a aftermarket belt on the bike and was told that was the issue so replaced it with the OEM belt reset the code same issue, I was then told a deflection check...
  2. Kawasaki Brute Force/Prairie/Bayou
    I have an 05 Kawi Prairie 360 2x4 model. I received it after sitting for couple years next to a barn. It ran fine when parked and was parked due to broken ball joint. After replacing the whole front end due to recall, I replaced carb, cleaned tank, etc. Fired right up but had a rattle inside the...
  3. Kawasaki Brute Force/Prairie/Bayou
    Hey I'm new to this forum. I just bought 08 brute force 750 from my buddy and it has no problems. When I took it out lastnight it ran perfect just like always. Rode bout 20 minutes and turned it off in the trails then it wouldn't start checked some stuff and it did not have spark. so I loaded...
  4. Kawasaki Brute Force/Prairie/Bayou
    Are there any causes for limp mode other than the belt switch? I have an 04 Prairie 700. I replaced the belt and ran a jumper wire to the belt switch any how. Reset belt light and it went away, yet the motor still act as if in limp mode. I don't think it has anything to do with the carbs. It...
1-4 of 4 Results
Top