Search Results for ‘timing’

Hello everyone, new member here, first post! I tore into my 2005 brute today for a top end rebuild. I bought it with around 2k miles (I don't remember exactly) and now it has around 2600. To start with symptoms: It has always ran OK but felt like it didn't have all the power that a brute...

Okay, so here is my issue. I just bought this quad and got it started after I cleaned the carb and recoil starter but it died out almost immediately. I've done timing before so I checked it and it was off. I loosened the chain tensioner and then took the chain off of the cam gear to adjust the...

does anyone on here know of a reliable atv mechanic in the southern CT area?????

I've been seeing a lot of people use the 6 degree advance key in there quads. Is there any other mods or adjustments that need to be done?.any feed back is appreciated thanx..

i had to replace piston do to low oil. (long story) Bought a wiesco piston, put it in and now i put everything back together. i set the timing like everybody says. set piston top dead and line marks on cam sprocket up etc... now it doesnt want to run. got good spark, and the intake seems to be...

I have a Kawasaki 360. It won’t start and backfires through the exhaust. It makes a very loud “BOOM”. Any ideas?

hello have to say thanks for the help previously but now i have another newbie question. have my V running good again so i want some more power. looking to add the upp crossover intake but really unsure how to tune my carbs after. also im thinking of doing the timing key just dont know exactly...

So im embarking on a journey with my first brute force motor. over the past year ive rebuilt from top to bottom a hand full of two strokes and a hand full of four strokes quads and bikes. my father in laws buddy found out that i was pretty handy with this stuff and asked if i could help him...

I think my atv is going to need new cam chains, they were replace last August, but i have put alot of miles and stress on them since then, I need some advice from anyone who has replaced them before, What tools do I need, what parts will i need to order besides the chains, like what gaskets...

So Ill try to make this short and sweet. I have replaced the coil bought a couple cdi's. Checked for continuity. I CANNOT get this stubborn thing to even spark. Any last ideas before I take it to a shop? If Im correct the ignition circut should be able to run by itself independant of the...

:eek:hey guys, i got a quick question, i have a master harmonic balancer/steering wheel puller,would this work on my v? i have not seen the flywheel but i want a 4-6 deg key, which is my next question, i ride hard mostly bottom and mid range and some top, not alot of room in the places i can...