valve

was preforming the 20 hr valve clearance check. Had problems getting the 10mm feeler gauge under the outside valves. later when I rolled the engine over to check other valves, I noticed that there is rust on the back of both the intake and exhaust cams. Called the dealer, they turned it into...

I have parted out my Brute that only had 1200 miles. I have everything and will ship right away if needed. The plastics are in good condition but I would prefer to sell those local due to shipping costs but besides that if you need diffs, valve covers, rockers, pistons, gauge clusters, cams...

I'm not quite sure what the problem is, but when I start my Mojave, (doesn't have any trouble starting) I put the choke on full and it runs just fine, slight exhaust popping when it is still warming up. Then when I take the choke off it idles at a normal speed and then slowly dies down and shuts...

I took the valve cover off motor, found out that the right rear threads were gone on the bridge and the bolt was snapped so I'm trying to find the replacement parts. The two bolts that hold the clamp on the main block are fine. When I go to websites to find parts the bolt is always listed for...

Hi guys. I have an ATV KAWASAKI Bayou 220 - 2001, and he presents sound off on adjusting the valves. I have the caliber of clearances and have the setting values​​, but I have a question: to make the adjustment the piston must be at PMS? How do I stop the piston in this position? The two valves...

after my bike wouldnt start or idle ive determined that the valves need to be adjusted after some helpfull advice but i still need some help with how exactly to adjust the valves like specifics on how to determine top dead center and how and when i will be adjusting which valves, any help or...