Kawasaki ATV Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 · (Edited)
i have a problem,my actuator is working when i put 12 volts to it but its not getting a signal from my switch,also my bike is not making that wining noise any more and my engine brake is not working ,that motor in there also works when hooked direct:confused:. are all there problem connected.
 

·
Registered
Joined
·
148 Posts
i have a problem,my actuator is working when i put 12 volts to it but its not getting a signal from my switch,also my bike is not making that wining noise any more and my engine brake is not working ,that motor in there also works when hooked direct:confused:. are all there problem connected.
Your 2wd and 4wd lite should be blinking back and forth. there is a time delay 2 tell u witch one is witch.:D
 

·
Registered
Joined
·
3 Posts
Discussion Starter · #3 ·
i have a problem,my actuator is working when i put 12 volts to it but its not getting a signal from my switch,also my bike is not making that wining noise any more and my engine brake is not working ,that motor in there also works when hooked direct:confused:. are all there problem connected.
Your 2wd and 4wd lite should be blinking back and forth. there is a time delay 2 tell u witch one is witch.:D
lite is not flashing its says 2wd and thats it my actuatar when before and it was flashing but not this time
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top