Kawasaki ATV Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
169 Posts
Discussion Starter #1
Hello guys pick up my new 2010 Kawi Brute Force 750i about two weeks ago, have not had time to write it much. Just wondering what you guys recommend on breaking it in other than what the manuals says to do. Any advise will be appreciated.
Frank
 

·
Registered
Joined
·
169 Posts
Discussion Starter #3
you know i heard that before, will see
 

·
Registered
Joined
·
379 Posts
race

Its ok to make the engine pull under load. But don't just race the engine at high rpms setting still....................The valves and rings need to seat properly............And yes after break in get that bad oil and filter out of there...........
 

·
Registered
Joined
·
17 Posts
It ok and good to ride it hard but dont just flogg the crap out of it.
The idea is not to keep it at the same rpm. You should ride it normal till the motor is completely warm through and through, flog it hard then go back to normal riding, its a good idea to do that for 20 minutes then let completely cool down then repeat. after about 3 or 4 times of that shes broke in
 
1 - 7 of 7 Posts
Top