My name is mark I drive a 2011 bruteforce 650 4x4i I smoked the belt bad yesterday I was going over an obstacle and wasnt in low my brand new belt had around 10 hours on it now it doesnt grab I can only go about 15 I know I have to replace it but should I deglaze or what should I look at or see so I can decide whether to deglaze or not?
If it's acting that bad it's gone. Get a new one and inspect the sheaves closing for wear spots. You might also be in limp mode because of the switch position. Be sure its in the ON position and do the belt reset after the new install.
Just got my first brute 750 on 30s and the belt that was on it had stock springs in it put a clutch kit in and went to ride hatfield and McCoy and no problems
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
Kawasaki ATV Forum
971.2K posts
52.3K members
Since 2002
KawieRiders.com is the largest Kawasaki ATV owner's forum with information for the Kawasaki KFX700, Brute Force, Prairie, Bayou, Mojave, Lakota and older model Kawasaki ATV's!