Kawasaki ATV Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
346 Posts
Discussion Starter #1
Does anyone yall know of CNC port heads? I know many people do it by hand, just curious. Thanks
 

·
Premium Member
Joined
·
23,817 Posts
the initial programming is expensive

cnc is no better than ones done by hand

in fact the programming is taken from ones done by hand

it just gives repeatability and is faster

then not all porting should be the same, hogged out heads are good for high rpm power
 
1 - 2 of 2 Posts
Top