Kawasaki ATV Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
477 Posts
Discussion Starter · #1 ·
I have searched but can't find what I'm looking for and I know I have seen it somewhere. Anyway how big of a bore can you go to on these cylinders and not have to re-sleeve. These cylinders can just be bored and then pistons installed, right? These don't require re-plating, right?

Thanks
 

·
Registered
Joined
·
433 Posts
I believe most say 84mm but I am pretty sure there are some out there 85mm running with no problems. No they do not require any replating..
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top