Kawasaki ATV Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
49 Posts
Discussion Starter · #1 ·
I have an 06 650i. I am getting ready to snorkel it, dynatek cdi and hmf slip-on. Can someone tell me a good starting point on jetting or someone with these mods help out? I am close to sea level.
 

·
Registered
Joined
·
302 Posts
HMF Recommended Jetting for Brute Force 650i (06-10)

MAINS: 2006-2009: Slip on: 165 Front-165 Rear Keihin Round
(These settings were determined on our dyno at 900ft - 60°F)
PILOT JETS: 40's
PILOT SCREW: ADJUST AS NEEDED
NEEDLES: SHIM AS NEEDED ( #4 FLAT WASHERS, BRASS OR STAINLESS STEEL)

ASSUMING YOUR ENGINE IS STOCK, I WOULD START WITH THIS. SEARCH THE FORUM, I'M KNOW THERE IS MORE INTEL.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top