Kawasaki ATV Forum banner

Oil pressure gauge question

1793 Views 4 Replies 4 Participants Last post by  blazer
Just a quick question - I am running a Mike Walker oil cooler (a plate goes between the oil filter and engine which taps off oil to the cooler). If I installed an oil pressure gauge sensor in one of the lines going to the oil cooler, would I get a true pressure reading? It would make installing the gauge really easy. Thanks.
1 - 5 of 5 Posts
yes it would be
You can also drill and tap right into the aluminum oil block that is sandwiched between the filter and motor.

1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.